Hi everyone, new member of the forum here, even if I was reading a lot since a little while. I wasn't sure if I needed to start a new thread or just post in here, but here we go:
Finally take the step and went to the is20 route for my 2017 DSG Alltrack last week, installed an IE downpipe while at it and was already running a JB4 since a little while on the is12.
I did the wastegate adaptation and I'm idling at 3.5254v.
I started to run everything on map 2 just to make sure everything was fine, and did some logs and sent them to George, he then recommended me last friday to set fuel bias to 100 and open loop to 60 and continue logging on map 2.
My problem is now a experience a drop in power when accelerating, like the car hesitate for a second or two during the acceleration, accelerate normal again along the rpm and massive drop of power, almost stalls before shifting, the tires even squeak when it happens. It always happens when on first gear, accelerating pedal to the floor, but happened also (If I remember correctly) on second gear. It's really freaking when it happens, and if I drive smoothly, everything is fine. I also noticed that when it happens and I'm logging, the JB4 mobile app freeze, I have to click manually "stop logging", and the rest of the app is responding. I'm really new to this, and the jb4 things, and understanding the charts so any help will be really appreciated since I don't want to damage anything. I don't know if it normal, but looking at the "gear" on the logs, its shows "9" at a moment
Here's my two last logs:
https://datazap.me/u/sim0n0/log-1595212529?log=0&data=1-4
https://datazap.me/u/sim0n0/log-1595212510?log=0&data=1-4
Thanks