JB4 Logging, stacking and Map 6 Discussion

[achoax]

3rd Gear E25 Pull: https://datazap.me/u/acoger25/log-1...-25-26-27-28-29&trim=5&tmin=74.36&tmax=100.00

Looking to setup a Map 6 soon... thoughts?

Running a Unitronic DP and IE CAI.

 

[Diggs24]

3rd Gear E25 Pull: https://datazap.me/u/acoger25/log-1...-25-26-27-28-29&trim=5&tmin=74.36&tmax=100.00

Looking to setup a Map 6 soon... thoughts?

Running a Unitronic DP and IE CAI.

Looks good.

 

[achoax]

Looks good.

Thanks Diggs. Any recommendations for a baseline Map 6? I've skimmed a large portion of the 400+ pages in this thread, but given my mods and corn juice I'm not really sure where to start.

 

[Diggs24]

Thanks Diggs. Any recommendations for a baseline Map 6? I've skimmed a large portion of the 400+ pages in this thread, but given my mods and corn juice I'm not really sure where to start.

https://datazap.me/u/diggs24/log-1502840894?log=0&data=1-3

 

[Diggs24]

You'll want an intercooler come springtime.

 

[achoax]

You'll want an intercooler come springtime.

Yup it's on the list. ECS' new FMIC kit is looking like a winner. I'm just enjoying this cool morning air at the moment. ?

 

[CC-Rider]

I have a 2016 DSG GTI, drop in AWE filter and a APR downpipe.

I've been working with George on some Map 6 settings and I think we're getting close. I've uploaded 3 logs. The first two were logged as a comparison because I felt the Map 6 setting was giving me the same performance as Map 2. George asked that I add another +1 boost from 4500-6000, but I added +1 across the entire RPM range (accidentally) so I might be pushing too much boost down low.

MAP 2 - https://datazap.me/u/ccar5458/map-2-12162019-0?log=0&data=1-2-3-4-11
Map 6 (first settings) - https://datazap.me/u/ccar5458/map-6-12162019?log=0&data=1-2-3-4-11
Map 6 (current settings shown below) - https://datazap.me/u/ccar5458/map-6-12262019?log=0&data=1-2-3-4-11

 

[Diggs24]

This is how you know you've gone too far down low (as JB4 can't show timing below 0).

https://datazap.me/u/ccar5458/map-6-12162019?log=0&data=1-26
https://datazap.me/u/ccar5458/map-6-12262019?log=0&data=1-25
Drop 1 psi 4k and below.

 

[CC-Rider]

This is how you know you've gone too far down low (as JB4 can't show timing below 0).

https://datazap.me/u/ccar5458/map-6-12162019?log=0&data=1-26
https://datazap.me/u/ccar5458/map-6-12262019?log=0&data=1-25
Drop 1 psi 4k and below.

Will do. I'll see if I can run another log today with the lower settings.

Does everything else look ok from 4500 and up?

 

[Diggs24]

yup

 

[Ramon64124]

New log:

https://datazap.me/u/ramon64124/e30-map-6-12-20-19?log=0&data=1-4

Clean?

 

[Diggs24]

yep

 

[CC-Rider]

Here are the two additional runs with the following settings:
https://datazap.me/u/ccar5458/map-6-12272019?log=0&data=1-2-3-4-11
https://datazap.me/u/ccar5458/map-6-122720192?log=0&data=1-2-3-4-11

 

[Diggs24]

1500 0
2000 2
2500 3
3000 3
3500 3.5
4000 4.5
4500 6

 

[CC-Rider]

That's where I started and the low end felt flat. I'll run another log with the lower Map 6 settings and a Map 2 log as a comparison.