Ed @ EQT
GOLFMK7 Official Sponsor
- Location
- Fairfield, CA
- Car(s)
- MK8 Golf R
Nice pics!
Nice! i think there is a slight port at the manifold as well, would love to see that.
My fast is happy.
uberpolka, nice pics!! what screw size and thread pitch and length did you end up going with for the wastegate actuator? thanks. also how did you clip on the wires without a proper connector to do the bench setup for the voltages? or did you buy an extra connector? i have micro-clips will it work?...have fun!!
Looking for these answers as well. My Mahle didn't come with mounting hardware. Ordered the connector and pins but it's slow to come over the ocean... believe it's stateside now though.
do you have the part# for the connector and pins please? thanks!
I bought this, not positive it's correct. Of course, the only one that would be used is the black connector and pins. ECS sells it, but it was $32 IIRC there. Ebay was about $12 USD.
https://www.ebay.com/itm/AUDI-VW-Sk...e=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649
Probably easier just to use tiny alligator clips if you have them. If not, I bet lowes or HD sell them for a couple bucks.
Don't forget to triple check you have all the coolant clamps in place on the hardline. I missed the vertical one next to the intake and made a big mess.
Sent from my Pixel 2 XL using Tapatalk