Hey guys!
Would Map1 on 91oct be fine for winter driving? Like Canada below 0C winters?
I just remember back when I had a Mazdaspeed 3 Cobb tuned I had a detuned winter map.
Thanks
Thanks George. Just to confirm this is the file that ends in 7_TEST4.hex correct?We have put up a new firmware version that you can get here: https://www.n54tech.com/forums/showthread.php?t=50428
The firmware will appear as 60/7//5
Changes are as follows:
1) Part throttle changes for smoother power delivery
2) Map 4 is now a valet map reducing boost by approximately 50% of stock
3) Map 0 is stock map with JB4 logging ability
4) Webasto and other auto warm systems triggering alarm whilst car is locked. This will also work for guys that have issues with dashcams left on over night that trigger the alarm.
With the valet working so well we working on boost per gear now to reduce the boost below stock or flash for guys that have stacked their units.
Thanks George. Just to confirm this is the file that ends in 7_TEST4.hex correct?
Sent from my SM-G950U1 using Tapatalk
Thanks George.Yes, you can actually remove it in any map you in. Later firmware will default the JB4 to 0 boost add and earlier version will add 4psi.
Map 0 in all cases will be stock pass through.
Hi everybody, did the flash of the newest version go well? I had several failures when checking checksum. I started to panic because it said there is no firmware on it right now and it will cause several warning lights to go on. Then I went back to the previous version. And this also needed two trials.Correct.
Hi everybody, did the flash of the newest version go well? I had several failures when checking checksum. I started to panic because it said there is no firmware on it right now and it will cause several warning lights to go on. Then I went back to the previous version. And this also needed two trials.
Gesendet von meinem ZUK Z2121 mit Tapatalk
Hi everybody, did the flash of the newest version go well? I had several failures when checking checksum. I started to panic because it said there is no firmware on it right now and it will cause several warning lights to go on. Then I went back to the previous version. And this also needed two trials.
Gesendet von meinem ZUK Z2121 mit Tapatalk
Can I run the JB4 with another device connected to the CANbus?
No, any other device connected to the OBD port creates latency on the CANbus. The CANbus was designed to allow one device at a time and further data being pulled may create safety issues on the network as well as bad signal to the JB4