So to be able to install my chassis mount splitter I needed to remove my SAI pump.
So I did.
Now I have a tube going from the valve to basically nowhere in the engine bay.
So long as I put some mesh over it I should be fine.. right?
As far as i'm aware since i'm catless and don't care about the CEL I should be good but I want to be sure there wasn't any potential unknown issues from this
So I did.
Now I have a tube going from the valve to basically nowhere in the engine bay.
So long as I put some mesh over it I should be fine.. right?
As far as i'm aware since i'm catless and don't care about the CEL I should be good but I want to be sure there wasn't any potential unknown issues from this