gc9n
Ready to race!
- Location
- None (International)
Should be fine, looks like mine
Make sure to print it with ABS or PETG, as PLA is not that heat resistant. Under the windsheild it may get reeeeaaaaly hot during the summer.
BTW. It's not that simple with 3Q0 camera, as the maximum length of an extension cable that is possible to use is around 20cm. Also the extension cable has to be 30 pin. The only way to do it right is to mount the control module to the windscreen and hide it under oem plastic cover.
Thanks for your response, yea sure the filament will be a good one maybe nylon.
About the cable. I didn't know that! The newer camera needs 30 pins? And only 20cm. That is changes everything...
Did encounder any problem with the 40cm in your camera. How did come into that conclusion?
Last edited: