TwinSnails
Ready to race!
- Location
- Colorado Springs, CO
- Car(s)
- B5 S4 Avant, Mk7 R
Brand new, never installed P3 V3 OBD2 vent gauge. Preinstalled from P3 in an OEM vent so it is entirely plug and play.
Mk7/7.5 Golf R spec with the blue lights but should fit GTIs as well.
This exact gauge
SOLD
Mk7/7.5 Golf R spec with the blue lights but should fit GTIs as well.
This exact gauge
P3 V3 OBD2 Gauge Features
- Plug and Play Install - plugs directly into your OBD2 port (want to keep your OBD2 port open? hard-wire harness kit also available)
- OEM Integration - installs in your vent for a sleek install while retaining air flow
- Versatility - read boost from multiple OEM sensors through OBD2 port or using optional P3 analog boost sensor
- Code Reading/Clearing - read and clear diagnostic trouble codes (DTCs) on the fly
P3 V3 Gauge Readouts (all readouts can be individually configured to read in either Imperial or Metric units)
- Boost (through OBD2 port using OEM sensors or with P3 analog boost sensor)
- Coolant temperature
- Air/Fuel ratio (can be read in AFR or Lambda)
- Vehicle speed (can be calibrated in 1% increments from -9% to +20%)
- Intake air temperature
- Throttle angle
- Ignition timing
- Engine RPM
- Exhaust gas temperature
- Battery voltage
- Programmable shift light
- Analog input 1 (brown wire) can allow gauge to read any 0-5 volt linear output sensor
- Analog input 2 (blue wire) can allow gauge to read any 0-5 volt linear output sensor
- Acceleration timers (0-60mph/0-100mph/60-130mph)
- Braking timers (60-0mph/100-0mph)
SOLD
Last edited: