Ryanw0's latest activity

Thank you man I really appreciate your time and response. Hoping to work on the car tmrw and check that out. Haven’t Had the time at all...

Hmm, this almost sounds like the strut bushing/bearings. How does everything attach up there, are there two nuts or only one holding the...

Update- only happens when I turn the wheel or going over bumps, definitely drivers front side. Makes me think sway bar links but those...

What areas of the front suspension and rear suspension needs to be torque to specs under the full weight of the car, specifically which...

I torqued everything in after I jacked up the subframe/brakes and steering knuckle up into the bottom of the coilover. Then dropped the...

Hmm, that's strange. In the video you specified rear, my initial impression was that it was a front clunk because you mentioned it felt...

Just installed Bc racing br coil overs and the front has been knocking a lot, usually more prevalent at lower speeds and when coming to...

Everything was tight, nothing had play but there was some grease or something right under the axle so that’s a bit alarming. Heres a...

Not sure how much help I can be, but if it's right under your feet look at anything that you had disconnected. My knee-jerk thought is...

If you use vice grips to hold the shaft, make sure you hold it as high on the shaft as you can. If you make ridges in the shaft at a...

Most of the time it will zip off with an impact gun

Fastest way is holding the shaft on the other side with a visegrip with rubber on the jaws to prevent marring. Or Specialty tool! I...

Thank you everyone for the help, I ended up getting everything installed, don’t know what I’d do without this forum. By chance does...

Thanks man, will try that

Need to keep the shaft still, if you can hold that tab and get in there with an offset wrench you can break it loose.