Kushdaiin's latest activity

Not much but did work on trying to plan a visit to a shop for bumper re-spray, headlight swap out, coilover adjustment, or just waiting...

Lowered it on EMD springs. Used the 'metal' 2x4 method. Not a bad install, one front strut was a real pain in the ass to get back in...

Installed some Meyle HD trailing arms. Mainly with the idea to improve the impact noise going out of sunken-in (max 1“ deep, with sharp...

Yep. Went from the 3Q0 to the 2Q0 camera (MQB MFK 3.0).

The one you have looks like it could work. It looks like you got it inserted but it won't properly seat (i.e., tabs aren't hooking up)...

2Q?

Inspired by @Cuzoe, swapped the lane assist camera to the newer third generation one. Initial testing is looking good.

I tapped ground at the grounding stud at the base of the A pillar under the trim. Your kit should already have a grounding loop...

Yes that pictogram you put together looks correct. This is the answer as to whether or not you need power/ground (it’s yes).

I know a guy

count me in regardless

Fusion 360, but yeah. Everything fit first try, but had to do a revision to figure out clearance for using the jack point. The outer...

It doesn't look like it at first but there's a male/female plug there. You need to take the OE pin and plug it into the opposite side of...

Laser scanner and solidworks? Either way, that's pretty cool. Does that inner fender air guide have only one screw or is the angle of...