Fried_Soap
Ready to race!
- Location
- La Jolla, CA
- Car(s)
- 2017 Golf TSI 5MT
I've just spent two hours trying to install the final touch to my new OEM GTI catback -- the rear valance. It is supposed to just smoothly "clip on" but something is off. On my old valance, these two prongs highlighted in green went into the little holes without any trouble, but the new valance's prongs will not sit in the slots(blue)(other one is hidden it is so far back); in fact, it seems like they're all in the wrong place.
I also have no clue what to put in those other holes highlighted with red in order to hold the ends in place. It seems like the GTI has an extra rubber part right there but VW's parts website and literally every single online resource I've seen is useless at showing me the lower bumper diagram...
Is there any difference between the GTI and Golf bumper? I was under the impression that they were identical, but mine sure isn't working right. Any help would be greatly appreciated...
I also have no clue what to put in those other holes highlighted with red in order to hold the ends in place. It seems like the GTI has an extra rubber part right there but VW's parts website and literally every single online resource I've seen is useless at showing me the lower bumper diagram...
Is there any difference between the GTI and Golf bumper? I was under the impression that they were identical, but mine sure isn't working right. Any help would be greatly appreciated...