Are you located in the BAY AREA? Can some one like me pick them up from you instead of shipping?
Interested in the Red version
please pm me for details thanks!
Do you have RHD version of these headlights?
Thanks
Sent from my SM-G950F using Tapatalk
Received my set, pretty bummed with the quality. They look ok, but the plastic screws for adjusting the left or right is so cheap. Stripped with one turn.
Also when adjusting them you cannot get the light cutoff To be horizontal with the ground. If you do use the static adjusters enough to get it horizontal you get really bad gaps between the bumper and bottom of the light.
Also the cutoff is not clean and there isn’t much vertical adjustment for the light output. Also the driver side has a little dust inside too.
Have used both the static adjusters and the other screw adjustments to try to get the light output to look good and not have crazy gaps between the lights and bumper
Sent from my iPhone using Tapatalk
Replied to your email.
NOTE
For those adjusting, we highly advise not using a phillips to adjust your beam pattern. Use a metric hex bit to adjust the lights. When installing you should center both the horizontal and vertical adjusters. Install the lights and only use the static adjusters to set the primary positioning of the lights and beam pattern. Then use the external horizontal and vertical adjusters to 'fine tune' the beam.
If the adjusters are stripping its most likely that the adjusters are overclocked. (Especially using a phillips) The heads will strip prior to breaking an internal joint. The external adjuster pieces can be replaced (modular), the internal joints/adjusters cannot be so please keep that in mind.
Hey OPDparts, I’ve had my lights for almost a year now but was thinking about changing the bulbs to a bluer color. Which HID kit did you guys use? Hylux or Morimoto? Thanks!
Sent from my iPhone using Tapatalk
Hey OPD parts
My headlights are super chewed up from a few mountain drives behind some cars with sticky tires. Like really chewed up. Is it possible to have them polished/restored by a detailer?
I notice there seems to be a layer on top of the main lenses, that can chip away. Polishing it would likely completely remove this layer.
What do you recommend i do besides just buying another set