GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

My DIY solution to cover the dash passenger airbag warning on/off

dr_mat

dr_mat

Go Kart Champion
Location
Berkshire
No text on ours, just lights, which go out.

Sent from my XT1562 using Tapatalk
 
dr_mat

dr_mat

Go Kart Champion
Location
Berkshire
You lot want to get your legal system under control.. How about you go back to settling all disagreements at high noon in the town square, mano a mano..?

Sent from my XT1562 using Tapatalk
 
Klaus1

Klaus1

New member
Location
Charlotte, NC USA
@OP Did you use a cutter in order to cut the vinyl? I would love to get a hold of the PSD if you did. I need to get my Sure Cuts a Lot up and running again w/ my Cricut.
 
O

OaklandGTI

Passed Driver's Ed
Location
Oakland, CA
Klaus, no I didn't cut it. The vendor cut it based on my specs.
The end result is wonderful!
 
S

splizaat

New member
Location
Oregon
Hey thanks guys...it's not just die-cut vinyl, it's actual black ink printed to two layers of blockout vinyl and then a matte laminate added over it. This makes sure absolutely zero light comes through and the laminate protects against scratching and UV.
 
You must log in or register to reply here.
Top