help for adaptation wastegate golf 7 gti

hi all members of the forum, I installed the new turbo is 38, I have downpipe and mapping stage 2 revo, I can not do the first adaptation of the turbo, can you tell me the electrical voltages of the wastegate that I have to check with the vcds?
thank you all

Here you go:


https://www.golfmk7.com/forums/showthread.php?t=43144

Ramon64124 said:

Here you go:


https://www.golfmk7.com/forums/showthread.php?t=43144

Click to expand...

Never got to see you set this. So assuming rod is at voltage you want....what do you do in OBD11 to acknowledge?

Diggs24 said:

Never got to see you set this. So assuming rod is at voltage you want....what do you do in OBD11 to acknowledge?

Click to expand...

Then you go to engine module and find the charge pressure actuator basic setting. (either under adaptation or basic setting), and run the test.

I receive this fault code when I insist on pulling the 3 gear or 4 gear several
15312 - Turbo/Super Charger Turbine Overspeed
P0049 00 [096] - -
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Mileage: 131642 km
Date: 2018.09.25
Time: 17:29:10

Engine speed: 4449.50 /min
Normed load value: 100.0 %
Vehicle speed: 140 km/h
Coolant temperature: 92 °C
Intake air temperature: 43 °C
Ambient air pressure: 990 mbar
Voltage terminal 30: 12.929 V
Unlearning counter according OBD: 40
Engine: operating status: PL
STATE_BPA[0]: OPM
Charge air pressure control valve position: target value: 98.02 %
Charge air pressure control valve position: actual value: 45.73 %
MAP_MES_SAE: 255 kPa
Charge air pressure control valve activation pulse duty factor: 20.16 %
Charge air pressure control valve voltage: position closed: 3.5107 V

I have 3.6 volts on the wastegate actuator, but the first wastegate adaptation is aborted