Just sharing my AMS Performance Intercooler experience from unboxing to some stock comparison photos and then as things go along if there are any concerns later I will report back.
Install went without issue. Everything lined up well except a couple of plastic air shields needs to be trimmed a little bit. Perhaps "needed" is not the right word, I chose to trim them so there was no tension on these little shields but you could easily not trim them and you would likely never know the difference.
Disclaimer - I collected these video's and pictures to help others and not because this is something I "do". I apologize for poor quality or missing information.
Unboxing video: https://youtu.be/MM2ofaOVFa8
Stock part comparisons: https://goo.gl/photos/gfTgpMHeidgAEVRf6
Even though the picture comparing the stock intake and output ports makes it look like the factory ports are larger - this is not the case, its just an optical illusion.
I will change the pictures to inline once I get them separately uploaded.
Install went without issue. Everything lined up well except a couple of plastic air shields needs to be trimmed a little bit. Perhaps "needed" is not the right word, I chose to trim them so there was no tension on these little shields but you could easily not trim them and you would likely never know the difference.
Disclaimer - I collected these video's and pictures to help others and not because this is something I "do". I apologize for poor quality or missing information.
Unboxing video: https://youtu.be/MM2ofaOVFa8
Stock part comparisons: https://goo.gl/photos/gfTgpMHeidgAEVRf6
Even though the picture comparing the stock intake and output ports makes it look like the factory ports are larger - this is not the case, its just an optical illusion.
I will change the pictures to inline once I get them separately uploaded.
