Could you take a pic ? If there is a gap where the bumper meets the grill it’s because of the grill not being completely flush, very easy to do because it needs to be reinstall at an specific angle and then pushed I until it clicks in place, even if you’ve done a hundred times it is very Easy to do because the screws will go in regardless
Sent from my iPhone using Tapatalk
Na it's not the grill, you remove that to get them, i've become a bit of an expert at getting the grill on properly after having that problem when i was replacing the standard with an ABT.
When the grills removed, where it sits on the bumper, there are 2 holes off centre at each side that look like they tighten the bumper to the frame, but they have no screws in them, when they look like they should have, i put 2 screws from the wheel arch in and they do tighten and fit perfectly. In other words my bumper is only held on with clips and the bolts on the arches, it's not an issue just wondering if it comes like that or if someone forgot to put them back in?
Sent from my SM-G950F using Tapatalk
