Finally (successfully) installed Macan calipers. Lots of headache (my stupidity). After bleeding all the brakes (Yay Im done!) I found a hub ring on the ground. But I also rotated the tires, soooo I had to jack up and figure out which tire it came from. Then as I'm putting away all the tools I find 2 brake pads..... I forgot to put them in the passenger side.... but I also pumped the brakes a couple times to make sure the pedal was firm...... sooooo 4 pistons were all the way out..... and I only had the single piston brake tool......... Soooooo I just squeezed the sh!t out of one and it compressed.... buuuuuut it made the other pistons protrude more and started leaking fluid...... So I spent the next 45 minutes squeezing the sh!t out of one piston, slowly compressing then squeezing the sh!t of the one next to it so it wouldnt pop out. Also lost a "H".
*edit* Are my rotors backwards? Fuuuuuuuuuuuuuuuuuuuuuu
*edit2**edit*OHGAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
*edit* Are my rotors backwards? Fuuuuuuuuuuuuuuuuuuuuuu
*edit2**edit*OHGAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
Last edited: