Csar3
New member
- Location
- Steel city
- Car(s)
- mqb
About a week ago I installed an RS3 brushless pump with the A2B harness (Black controller). Everything was running fine until this morning when I was commuting to work and the car lost all power.
I was able to get it to the side of the road, but the car would not start. I had it towed home, did a scan and it came back with the following codes:
P025A Fuel Pump Module Control Circuit/Open
P025C Fuel Pump Module Control Low
Things I've checked:
20A fuse - Not blown
All connectors are correctly pinned
The ground is secured to bare metal
Is there anything else I should look at before I pull the pump out? Could it be a bad controller?
I was able to get it to the side of the road, but the car would not start. I had it towed home, did a scan and it came back with the following codes:
P025A Fuel Pump Module Control Circuit/Open
P025C Fuel Pump Module Control Low
Things I've checked:
20A fuse - Not blown
All connectors are correctly pinned
The ground is secured to bare metal
Is there anything else I should look at before I pull the pump out? Could it be a bad controller?