I’ve tried but for some reason my VCDS doesn't let me run a full auto scan, tablet hardware or VAGCOM needs upgradingFull autoscan please
I’ve tried but for some reason my VCDS doesn't let me run a full auto scan, tablet hardware or VAGCOM needs upgradingFull autoscan please
As soon as I sort it out I’ll post it.Full autoscan please
Pirated?I’ve tried but for some reason my VCDS doesn't let me run a full auto scan, tablet hardware or VAGCOM needs upgrading
Weird!I hope not paid a pretty penny for a diagnostic tablet with software support.
This was a reply on Ross tech forum re similar query to mine, mine uses UDS protocol
“ We've found an issue with recent builds of VCDS and autoscanning vehicles with a UDSgateway (like your MLB-Evo based Q5). New builds are ready, just stay tuned for an announcement here “
BCM, fuse and ground nothing morehello, can you tell me where the heated seats wiring goes in the vehicle ? thank you.
And the seats themselves!BCM, fuse and ground nothing more![]()
it's getting harder on that side, I just ran awayAnd the seats themselves!![]()
Measure the pads with the multimeter device, if the system is not complete, the pads are faulty. Or incomplete codinghello, I connected my heated seats, everything is well connected, I also did the coding correctly and my seats do not heat up
Airbag modules?? What faults have you got. Post an Autoscan.Got a quick question for the Heated Seats Retrofit Masters in this thread:
I swapped the OEM heated seats in my 2015 TDI SE with GTI (heated) seats; the seats work (adjustments, heat etc.) but I didn't think to swap the airbags modules from the old seats, so now of course I have the airbag faults.
Is there anything I could do to get rid of the faults, other than the obvious modules swap?
its not oem for sure, oem is a lot more expensive but its kind of the same