GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Displaying ethanol content on VADPro via custom sensor

replicate

Go Kart Newbie
Location
Downunder
Hey guys

I know there are a few cleaver guys on here that have done their fair share of can sniffing. Hopefully someone can help here as this is a little beyond my abilities.

I have a VADpro, which is an excellent device, I really like it. What I'm trying to do is display ethanol content via a custom sensor, which you can create via the DSS software. My car is flex tuned via a custom tune. Using the VAG continental flex sensor. The VADPro asks for a bunch of information to configure the sensor and this is where I'm stuck. All I know is the PID and that's it. Picture below is what it asks for, configuration shown is from their solution which requires you to wire the flex sensor into the back of the device, which I'd rather avoid if possible since it should be available over the can bus. Has anyone had success in displaying ethanol content via this or a similar device?

1679014812494.png
 
Top