Search results

I am looking to get the Wife's R dynoed this weekend. I am curious how to have the car hooked up for an ignition signal in order to get torque. On our old MKV, there was a wire in the loom near cyl #1 that we isolated for an RPM signal. Searched alot for this, and havent had any luck yet...

Recently installed a new Miltek valved exhaust system/ Noticed after install that the exhaust tone was not changing with mode selection. Exhaust is indeed coming from the outer pipes regardless of mode. Borescoped the exhaust, and noticed that during startup, the vales "cycle from open, to...

This was posted in a MK7 Golf/GTI/R forum on Facebook: "MQB DQ250 DSG Update. Hello all, We regret to inform you that since release it has come to our attention that a native issue can cause the transmission’s mechatronics unit to “brick” during any burn. This issue is only present on MQB DQ250...

Once upon a time in Mexico.... Here is a quick run down: 2015 Golf R: Stock 2014 STI sedan Downpipe Catback Intake Tune Short Throw shifter Carbon Fiber Driveshaft Full engine/trans mounts Lightweight wheels and bigger tires ______________________________________________________ Did 2...

Starting to look for wheels, but im not too good at estimating offsets and such We would prefer the lower offset wheel for the concave look, but the stock Cadiz is a +50 offset. Car will likely be lowered on VWR springs and likely running a 265 tire, unless that will be too much. Any help is...

Supposedly it left Brunswick yesterday. Coming into Houston March 3!! :D