Search results

sold!!!!!!

sold!!!!!!!!!!!!!! gone!!!!!!!!

all sold in this category. i have a kerscher cf splitter and superpro 24mm rear sway bar for GOLF R on other sections!!! I don’t mind shipping at buyer’s cost. I will supervise install of any locals who pick up at my house. I will provide tools, you provide your hands. Apr intake. Includes SRI...

All prices are picked up Orange County CA 92708 Video of all the stuff https://youtu.be/gkx05CriY8U I don’t mind shipping smaller items but at buyer’s cost. Cravenspeed platypus front plate holder SOLD SuperPro 24mm rear sway bar w urethane bushings for R only $200 picked up Kerscher cf lip...

haha. it actually kinda does.

Over this past weekend I made my own "splitter" / lip out of 1/4 inch abs. The template was from my Kerscher splitter then using a jigsaw cut it out. Then I used to heat gun to make the s curves. All of my work was eyeballed. No router or fancy equipment for this install. I think it came out...

made my own "splitter" / lip out of 1/4 inch abs. used to heat gun to make the s curves.

used online wheel configurator to see what turbo wheels would look like and even dropped. http://b2c-en.ronal-wheels.com/article/rims/car_selection/rim_selection_3D/

check out my blog and youtube in my signature for details. this was measured to the wheels well technically axle. you are referring to flywheel/engine hp. take a look at this link to explain https://www.carthrottle.com/post/the-difference-between-bhp-and-whp-explained/

did few dyno runs at AU Tuning today testing out the BK Motorsports Tuning Box baseline run was 260whp 271tq and with the box set to 'max' it put down 294whp 304tq video https://youtu.be/I0V_AN9o9HA

installed Bk Motorsports Tuning Box and finally washed her after many weeks of cold, rain and laziness.

Sold!!!!!

not too bad. taking my time and not dropping the exhaust took me 45 minutes or so total.

got a dent from a shopping cart due to wind and downgrade

installed superpro rsb. knocked out a lot of that plowing understeer.

ordered SuperPro rear sway bar. review will come as soon as i get that sucka.

I was about to buy a new FiST but because the salesguy lied after I drove 75 miles to get it, I told him to kick rocks and I went to a VW dealer and picked up an R for a steal. Obviously much different cars but I have 2 little kids and it as tight for them while the R same as GTI has rear room...

Tested!!! another piggy back - Tuningbox did few dyno runs at AU Tuning today testing out the BK Motorsports Tuning Box baseline run was 260whp 271tq and with the box set to 'max' it put down 294whp 304tq This is on a Dynapak front wheels only. Only bolt on is Apr intake. 91 octane So Cal...

you may want the better steel since you're in the east coast.

thanks. we are having some warm days 80s right now.