Search results

I purchased both clock springs from a recycle'r in Germany......both came off low mileage cars apparently. Hopefully you won't be chewing through clock springs like me.

My original clock spring was also a 5Q1 953 569......I still needed an adapter to move to the heated steering wheel clock spring (5Q1 953 569 B) There is still a problem though......this new arrangement works for a week or two before giving out. I have tried a new clock spring and had the...

Just search for a "Fuse Tapp" and you should have many options at your disposal. As for the harness, I am not sure what your existing wiring loom accommodates. My guess would be the Nuje adaptor for 5Q0-5Q0 would do the trick.

I finally received my replacement clock spring. Swapped it out and presto.....my heated steering wheel came back from the dead. Thank you for all your suggestions in troubleshooting this issue. :)

I got 2 Ohms so the element is not the issue. Looking at the AMV, I noticed I was getting a value for the temp sensor. I remember getting and actual temperature when it was working. This may be my imagination though. If anyone has a functioning system, could you have a look and see what...

Some info for @Nuje

The code does return when cleared but not immediately......It reappears I imagine once I try to enable the heating function. I did not ohm it out. I should though. What resistance would be considered normal? Something really low I would think. If the element has failed, should it show up as...

After a month of enjoying my heated steering wheel I have lost the heating function. 796675 - Heated Steering Wheel B1538 04 [008] - Internal System Fault Intermittent - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Status...

@Cuzoe Welcome back....I hope you enjoyed your trip :) My dash trim color is pretty close in color to the trim pieces short the carbon fiber pattern. Sounds like I am 💩 out of luck. I guess I will have to buy a matching set and swap them all out. Bummer.

Looking for some help. I am in the process of collecting the parts required to upgrade my ambient lighting setup in my 2019 Alltrack. I have everything except for the Light strip for the rear door cards. My car did not come with the light strip in the rear....doesn't even have the aluminum...

I am positive that these faults were not present prior to the AID install. I will go through the coding again. Must be a rogue bit somewhere in there :)

The install I just completed was with a B unit from China via AliExpress. Dealer had no issues coding it for Imo/CP. From what I understand, if you have a mk7.5, the B version is the way to go. Price difference is not worth going for the earlier HW/SW. Specifically, the part I purchased was...

Good morning all and happy Thanksgiving :) A couple of faults reappear. They don't seem to affect the functionality of the vehicle in any way. I clear them successfully but after a while they reappear. Hopefully someone has had this issue and found a solution. Address 13: Auto Dist. Reg...

@Cuzoe I remember reading one of your posts where you outlined how to get the cover art to show up on the AID. I can't seem to locate that thread now. Would you remember off the top of your head where I would find that option? If I remember correctly, it was a long coding option that was...

By the way, I thought I would paste the procedure that worked for me regarding the Steering Angle Sensor off of the VCDS forum: This may be useful to someone that runs into the same problem. Engine at idle. [44-Steering Assist] Rotate steering wheel 90deg left then center, 90deg right then...

Awesome....I will give that a try. Thanks :)

Sorry about the Code Tag guys.....first time I tried it and managed to mess it up :( @Cuzoe Got rid of the TPMS issue....long coding in the instrument cluster. I will try the link for the 5F fault. Thanks @Nuje Got the maps to work but like @bbusato, I needed...

Finally got it to accept the procedure!!! :) As you had suspected @Cuzoe , once the steering angle was sorted, all the other faaults melted away. The only one that remains is on 5F....Check Software Version Management A couple of other issues, the maps don't load up on the AID.....just an...

I tried the non VCDS and VCDS procedure without success. Getting a Not Initialized error on the steering angle sensor now (44-Steering Assit) Wednesday,23,November,2022,14:15:14:16365 VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64 VCDS Version: 22.9.0.0 HEX-V2 CB: 0.4622.4...

Thanks for your input @Cuzoe . I tred to clear the steering angle sensor without success. I took a peak at the measuring values and found IDE04443-MA300815 Steering Angle Sensor Malfunction. I then had a look at the long coding but VCDS does not provide any labels for that module. I verified...