Search results

I am out on this one, sourced one locally yesterday. Thanks!

Bump.

Sent you PM

Cool, Can you PM your ask and if you have a pic

Based in CO, will pay shipping, I believe the part # is 5QM254501G

do you have part # and would you consider shipping, obviously at my cost? looking for stock DP only for 2016 Mk7 GTi

Idle is good at the minute - smooth, agree on RS7 idle is/was a tad rough..there is a noticeable improvement from what I can tell.

I had white powder coat for a while, PITA keeping them clean but looks great white on white, changed mine last year.

RS7 previously, seems better, but only driven couple miles and still getting used to the APR tune upgrade, feels like I’m stock again low down..but will give it a week or two to settle in.

5.7ltrs or Motul and a set of Brisk Racing Silver Sparks!!

Prepped for BlackVue DR900s-2CH and P3 vent gauge by wrapping all the cables with cloth tape for a couple hours!! Sheez...

Haven’t posted in a while - new updates are pretty much cosmetic - powder coat wheels - super chrome base, fool’s penny and clear vision top coat (prismatic). Also wrapped the car Avery rising sun colorflow and matte black. Not power mods until next year.

Got the @apr snap, crackle and pop tune.....!! Mmmm rice crispies!!!!!!!

Finally got a dyno run in.

APR CBE tip, Y-pipe and hangers replaced, winter wheels put on, service and a dyno run @ 5280ft ASL, 50f

Loaded 4xAustin rims, 4 x Bridgestone AS and 4 x Winter wheel and Blizzak. APR CBE work, service, tires/wheels work and hopefully time for first stg2 dyno run tomorrow! 80 degrees today but alas 30’s and snow tomorrow.

Went to the PG!

You had to pay for their shipping damage? Da-fuk....

New plate on.

Thanks, I got a pure white/clear coat touch up stick set from a VW dealer for $12 which matched the car.