Search results

Has anyone heard of an ETA on when the repair will be available on this? I was notified that there was a recall in February 2024 and from VW's web site there is still not a repair available. My VIN fall within the recall, just wondering when I can get it fixed. Seems like an excessively long...

I noticed today that when I turned on my rear defogger it started to work then seemed to stop working. Turned it off for a little bit and back on and it did the same thing. I could see the window starting to clear, then a little while later it was fully fogged again. Has never been an issue...

I'm at 83k on my 2015 and still have some life left in them. Plan on doing pads and rotors soon, just picked up a full set at a great price for someone that bought them and sold the car before doing the brakes.

Just took it to a local VW guy. He was not there but one of the guys there ran a VCDS scan. 4 intermittent codes came up: 23096 - Intake Air Temp Sensor (G42) P0113 00 [032] - Signal too High - Intermittent - Not Confirmed - Tested Since Memory Clear 15358 - Engine Torque Monitor 2 P1335 00...

Just started having EPC issue. EPC light comes on, car goes to limp mode. Shut off and restart, EPC clears , car runs fine. No codes or check engine. This has happened twice in the last week along with occasional multiple start & stall issue. Car is 2015 6MT and has 81,000 miles. Spark plugs...

2015 SE 6MT

My 2015 GTI 2 door SE 6MT. Purchased new in August 2015.

I run 33 psi in my 235/40 General AS-05's and the wear across the tires is even. I just checked tread depth across all tires when I took my winter set off.

Before I order a new part wanted to see if anyone in the NJ area had an undamaged lower center grille that they want to sell. I had a little run in with an animal over the winter and have a section of my grille missing😞 Must be in perfect condition, no broken tabs, no damage to the grille...

FYI, the Pro license is NOT transferrable

I see there are both solid and hollow/tubular types available. What are the advantages/disadvantages of solid vs. hollow tube type sway bars? Basically just looking for a rear - On stock suspension - Daily driver car so I do not need or want anything too aggressive. Thanks....

Long story short is the DKM was removed and returned on an RMA from ECS after working with DKM support. Car now has a South Bend Stage 2 Daily installed and all is good. Looks to have been a defective pressure plate according to DKM support.

Any issues? I have been having issues with mine. I have about 3500 miles on it now and have had some issues since it was installed. 1) Clutch still lets out right at the floor. Had to remove the pedal stop but you still barely need to move your foot and it starts to engage. 2) This is the BIG...

Looks to have been the clutch pedal stop. I had an aftermarket one in from when the OEM clutch was in the car, changed it to just the first pad when I got the new clutch, which is. A few nights ago I completely removed it and have not had the issue since then. To answer your comments. Bleeding...

If you have replaced your trans oil what did you use? I have put a little under 3000 miles on the car with Motul Gear 300 75w90. I have not been happy with it at all, especially when hot. Shifting becomes much higher effort and notchier. I am going to replace it ASAP and want to know what others...

Yes, with the car off it is fine. Since posting this I removed the pedal stop. I had previously installed a taller one when the stock clutch was in. I had since removed all of the additional thickness and it was down the last pad. After removing it completely I have not been able to duplicate my...

I am having a similar issue. However, NOT when cold, it happens after the car is hot. Shifting becomes notchier with more effort needed, and when arriving home it is nearly impossible to get into reverse and very difficult to get into 1st. Shutting off the car the shifter returns to normal...

2015 GTI 6MT. When cold I do not have any issues. After the car has been driven for a while and is fully warmed up it becomes very difficult to shift. High effort is needed. It becomes very hard to get into 1st, and is nearly impossible to get into reverse. I had a DKM Stage 2 clutch installed...

Amwell Auto Body in Hillsborough.

I've had a JB1 since 2500 miles running MAP6 with low boost at 3500 RPM and below. My stock clutch made it to 51,600 miles before I started getting frequent slip. Just had a DKM Stage 2 clutch installed. I am 100% happy with this clutch at far less than a South Bend. You need to remember, at...