Another question. Anyone got a list of bolts and part numbers needed for clutch replacement? So far I got these:
Throwout bearing bolts (3): N90847002
Front Axel bolts (2): WHT005437A
Dogbone/Pendulum mount bolts: N91201001, N10699401, N91167101
I couldn't go further than 75 ft lb either. Tried my best with the 1/4 turn but as you can see in my picture.....didn't happen lol. It looks flushed to me and couldn't find anything wrong with it. I'm just going to leave it as that.
Should I replace rms with iabed or oem? I heard oem updated the seal? My current seal is not leaking but will have a shop replace my clutch soon so I'm trying to decide whether I should have them replace the rms as well. My car is at 55k miles.
Oil change, replaced cabin filter, installed aerofabb goodies, added powerflex hybrid insert and rear subframe harmonic damper.
Took 034 insert out after about 5 years...the insert doesn't look too bad.
I just got the BFI engine/trans mount installed. I was expecting much more NVH when I got the BFI mounts installed paired with the 034 dogbone insert but I can barely feel anything. Will be putting the powerflex in this weekend along with the rear subframe harmonic damper.
Will be installing this soon and I just wanted to make sure if I got the process correct. Installation is the same as any other dogbone insert except for this one you need to remove the lower puck. To remove the puck, I need to cut into the plastic and it will fall out? Removing the pendulum...