GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Search results

  1. R

    Please help, loads of fault codes with flashing glow plug light

    Ah thanks for letting me know that. I think I will have to find a local specialist that can code in the radar then and hope it’s not a dead unit. Cheers for your help.
  2. R

    Please help, loads of fault codes with flashing glow plug light

    Hi mate, I think I’ve narrowed it down to the radar sensor. If I disconnect it and then turn on the car I don’t get the flashing glow plug symbol and don’t get many of the fault codes. I’m thinking after some research that the radar has been swapped out at some point and was never coded back in...
  3. R

    Please help, loads of fault codes with flashing glow plug light

    Hi, I’m hoping for some help regarding quite a few fault codes. ACC, stop start is unavailable and also a flashing orange glow plug light on the dashboard although the car doesn’t seem to be in limp mode. Please see the list of codes below and hopefully some of you can shed some light on it...
  4. R

    Acc,Front assist and start-stop problem

    Ah okay. Well I’m hoping the databus errors are being caused from the battery which in turn is causing the lack of communication between the modules, this is what I’ve read on this thread anyway so thought it would be worth a try. I’ll try the new battery I have on order coding it in with obd11...
  5. R

    Acc,Front assist and start-stop problem

    Yes I have checked the connector and also the radar and it’s like new. The car has only done 45k 15 plate. Forgive me but what’s module 13? It could be that the free scanning app I used might not be very good at picking up all the modules. I have got an obd11 pro pack on order should get it...
  6. R

    Acc,Front assist and start-stop problem

    Hi, newbie here and apologies for resurrecting an older thread. I have the same issue regarding ACC, start stop, hill assist and the anti crash systems not functioning. I ran a check on the codes yesterday with my vgate plug and got the following codes below. Do you think that changing my...
Top