Search results

After Daks mentioned that the IE intake makes more noise because of its velocity stack I decided to make one for my APR PEX. After hour of research and multiple thoughts I decided on this design. The inlet (100mm/4 inch) of the APR tapers and bends 90 degrees so I printed this @ 97mm and...

DIAB...

Fuc**** lightning strike on your turbo.... 😂

Daks reveals he actually has a TPC20 and not HPA 😳

Ya maybe just get a different cup...

Clips into your glove box. Savadicar TJ Multi-Function Drink Cup Phone Holder, 2 in 1 Bolt-on Stand Bracket Organizer for 1997-2006 Jeep Wrangler TJ https://a.co/d/e7hpQM9 RAM Mounts (RAM-B-132-400U) RAM MOUNTS Level Cup 16oz Drink Holder with RAM Tough-Claw Mount RAM-B-132-400U for Motorcycle...

Eh I guess. I don't track the car so its mostly for the bling. I already purchased a used set of rear calipers to paint match..... :ROFLMAO:

Purchased from R1 Concepts with Black Friday (25% off) deals.

Non-PP. First 1/2 of the pedal is soft then it bites. I just daily the car so may change the brake assist settings later.

Finally installed today. Many thanks to @PatMc and Auto Brake Solutions for fixing my stripped caliper. Enkei RPF1 18x7.5 +48. Needed 17.5 spacers and 90mm studs. Maybe 3mm clearence?

Finally (successfully) installed Macan calipers. Lots of headache (my stupidity). After bleeding all the brakes (Yay Im done!) I found a hub ring on the ground. But I also rotated the tires, soooo I had to jack up and figure out which tire it came from. Then as I'm putting away all the tools I...

Wait a few weeks for the springs to settle and then see if it levels out.

If your raising/lowering your suspension you'll need to adjust your sway bar end links. I'm lowered on EMD springs (1.2" drop)/B8 and I would get a cyclical squeek on cold stats. After getting adjustable endlinks and adjusting to remove preload no more squeek.

K20 swap 👍

https://www.goapr.com/products/engine_hardware/intake/apr_open_pex_intake_system_-_mqb_18t_and_20t/...

Can speed bleeders be used on these? To make bleeding "easier"? :unsure:

Engine/transmission mounts, then IS38 upgrade. IS38 will move the powerband to the upper RPM range. If you’re still losing traction then tires. IMO LSD is if you track your car. If you do that might as well switch out that DKM clutch too….

Can you use speed bleeders for the brakes? Most use Motive Power Bleeder to pressurize system to 30PSI to get past the ABS sensor then crack open. I’ve seen videos on speed bleeders and you pump the brakes to pressurize the system and move fluid. Would speed bleeders be pointless since the...

Installed BFI Stage 1 Engine Mount and transmission mount insert. Used GTIJakes video on how to drill out the OEM transmission mount rivets. Originally I had Stage 2 85A durometer AliExpress engine/transmission mounts since they were cheap and look exactly like the ECS ones minus the markup...

Tried installing Macan calipers a few weeks ago and stripped out the cross-over tube threads. Called one place here and they recommended buying a new caliper; another said they could "try" re-thread/helicoil. Was gonna buy Time Serts and attempt to repair myself but it probably would've ended in...