GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Search results

  1. V

    Stock fuel lines on ethanol

    Over 2 years on full e85
  2. V

    Recaro Sporster CS install mk7 gti

    I just used pre-shrunk heat shrink tubing to hold the resistor. Been like that for 2 years no issue
  3. V

    Show us your MK7

  4. V

    Recaro Sporster CS install mk7 gti

    Yes gray wire is a ground and needs to be grounded or you will get a Occupancy sensor ground fault.
  5. V

    Mk7 dragy times, 60-130, 1/8, 1/4,

    Sorry couldn't tell you the details because I would be guessing to be honest with you. He did a bunch of things, also keep in mind that this was when Cobb first released MPI support two years ago. The run was done at 3,540 lbs with driver, 3126 DA, and airride
  6. V

    Mk7 dragy times, 60-130, 1/8, 1/4,

    I also had "overheat" warnings but worked them out with my tuner with ECU and TCU tweaks. Here's what my Vortex Std did when I was running it:
  7. V

    60-100 mph times

    Golf-R full weight +100lbs airride.
  8. V

    EQT DSG base map

    475 ft/lbs is a torque limit request not clamping pressure. Dq250 has a physical limit of ~17-18 Bar of pressure
  9. V

    FS: Konig Oversteer 19x8.5 ET42 San Diego

    About same price as these cast Konigs... Lol
  10. V

    FS: Konig Oversteer 19x8.5 ET42 San Diego

    https://www.mrgraceco.com/store/p53/NON-BMW_EUROPEAN_TITANIUM_STUD_CONVERSION.html
  11. V

    Sheared oil pan bolt thread

    The mid-pan can be replaced but you'll have to remove the transmission to do so. It's about a $600-800 job.
  12. V

    Tomioka Racing IHX turbo upgrade for all Golf MK7

    I couldn't confirm it but I was told by an industry insider that Zage manufacturers for both Garrett and BorgeWarner EFR for Asian markets.
  13. V

    Tomioka Racing IHX turbo upgrade for all Golf MK7

    Yes the 675 is a GTX3071R but it's made by Zage. http://www.zageturbo.com/index.php/main/products#/details?cid=101&id=567
  14. V

    Tomioka Racing IHX turbo upgrade for all Golf MK7

    Using Tomioka numbering convention I would say. STD Vortex = 550 XL Vortex = 600 Both turbos are made by Zage.
  15. V

    EQT Vortex XL Spark Plugs.

    I run 3 steps colder Adamantium spark plugs
  16. V

    Recaro Sporster CS install mk7 gti

    You need the occupancy sensor, seat rail sensors, and resistors for seat air bags connected for all faults to be removed. There is a different fault for each.
  17. V

    Mk7 Seat resistors for airbags

    https://www.golfmk7.com/forums/index.php?threads/recaro-sporster-cs-install-mk7-gti.360636/
  18. V

    10% OFF In-Stock RECARO Seats

    Sportser CS have been discontinued. Current model is GT https://www.maperformance.com/products/recaro-new-sportster-gt-seats
Top