flakomk6
Ready to race!
Yes man, simple too.Nice man, I like the black you added to them too.
Yes man, simple too.Nice man, I like the black you added to them too.
Did you just buy some 3m wrap?Yes man, simple too.
i got some self-etching primer, gave it 2-3 coats and then 2-3 coats of black gloss spray paintDid you just buy some 3m wrap?
I was thinking about painting my brace, but I think wrapping it might be better
Wait until you need to put it back in!
Wait until you need to put it back in!
Serious talk for a moment. Get a friend, or at a minimum a wife or gf, to help when you're putting it back in. You don't want to be under the transmission when you need that third hand trying to get it back in.I’m just pretending I don’t need to do that at the moment ?. It’s best to just man handle it out so I’ll probably just do that to put it back in. If it takes more then an hour the subframe is coming off tho.
Is that only trans off? Or clutch installed, waiting to put trans back on?
Is that only trans off? Or clutch installed, waiting to put trans back on?
Lol. I told you this was going to be an issue! HahaOnly trans off. I got everything off after that and made it to the RMS but hit a road block when I was not able to find something of the correct diameter to press the RMS into the iABED flange. I pressed it in with a plate that I found but it’s not in far enough. About to run to the hardware store to find something in a bit.
Lol. I told you this was going to be an issue! Haha
Lower the engine 3-4 inches or so....it'll go right around the subframe. Thank me laterI’m just pretending I don’t need to do that at the moment ?. It’s best to just man handle it out so I’ll probably just do that to put it back in. If it takes more then an hour the subframe is coming off tho.
Yes you did lol. I figured with all the junk I have there had to be something that would fit. It should come pressed in already!!