GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Mini7's latest activity

  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    Here are some data of the pulls showing the higher boost figures.
    • 34DDC9E4-F039-4232-BA58-1A5E8684FF77.jpeg
    • DF02E3CB-0D01-46FD-8E8B-96F34C761908.jpeg
    • D249FA39-8965-4465-881F-DAE2CE4F063A.jpeg
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    I bought them direct from PB. I wanted something that would fit under a 17” wheel. They work through their Dealer network. The 350x34...
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    They do. I need to dig up the photos. I may have a link in the first page to the install.
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    I didn’t measure WG duty cycle. Need to check whether I can measure injector duty cycle on OBD11. I know I got some fuel dilution based...
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    Actual Boost is following Specified Boost. There is some lag here and there. Logged on the highway so did some 4th and 5th gear pulls to...
    • DF16B3F1-5BDC-4F82-B9E0-2DE4A7C98BDE.png
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    I can’t say that I do. Low shaft speeds are high speed corners. High shaft speeds is when I hit a bump or take curb, which is when the...
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    14.31psi atmospheric pressure at 761ft
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    761ft above sea level.
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    That was with the car off. Im not getting a code. Wanted to rule this out as a possibility. The lower and upper values are in the...
  • M
    Mini7 replied to the thread OBD11 wastegate adaptation.
    Checking my Wastegate calibration on OBD11 Charge pressure actuator acknowledgment is the parameter to check. Correct?
    • 2C8F8492-D5E8-46A7-85CE-A0E7726C0A06.jpeg
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    IS38 Wastegate Voltage I’m in Engine/Live Values Is charge pressure actuator, acknowledgment the right parameter I’m looking for? When...
    • 9E911DD9-E61F-4820-91FB-64105F1B9822.jpeg
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    Not yet. Going to use my OBD11 to log. Need to figure out why I’m down on power. I’m on a time crunch to be able dial in a custom...
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    I’m in black with Audi.
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    I would do a quick bleed to make sure you have all the air out the system. The last 2500 miles would have shaken the last few bubbles...
  • M
    Mini7 replied to the thread 2017 GTi PP at VIR.
    Thank you for this. Going to use it tomorrow. I want to get my front Verkline LCAs installed but need to get this issue resolve first...
Top