So, an update on today's progress.
I started with the PDC module bracket. Using a YouTube video, I found the exact location of it. It's supposed to clip into the side of the BCM plastic holder. However, I had an issue - the bracket was too big to fit as there was a huge black/red cable around there that I didn't wanna temper with. I ended up cutting the excess plastic around the actual BCM holder, so I was left with something like this (notice I marked the two tabs that needs to slide in):
Unfortunately, even after cutting it, I wasn't able to slide it in the designated place. It seems the holes are smaller than the tabs on the BCM module bracket, which doesn't make sense to me. I ended up using double sided tape for now until I figure out how it works. I took a picture - you can see the marked tabs where the bracket should slide in, they're perfectly aligned with the bracket tabs:
I then moved to disconnecting the rear sensors loom from the
left side of the vehicle and routing it on the
right side this time. Routing the cables from the left side of the vehicle behind the center console plastics
is not an easy task. I had to improvise. I ended up doing an okay job, but definitely not what I was expecting.
I also found the proper location for the speaker this time.
I took a picture so you guys can see. The speaker fits right there as the holes align with the holes on the metal. I used one rivet I found laying around there to hold one side which works for now, but I'm sure the original one uses two OEM rivets specific for this.
So:
- Cable routed.
- Module mounted.
- Speaker connected.
I left the wiring loom for the rear sensors disconnected as I need to drill another 2 18mm holes for the side sensors and my cutting device still hasn't arrived.
If anyone knows the location of the front buzzer, that'd be awesome.