OBD scanner, its just a regular fault code.At what stage can this message be presented? No Odis or VCDS!
OBD scanner, its just a regular fault code.At what stage can this message be presented? No Odis or VCDS!
OBD scanner, its just a regular fault code.
Hi, one question, who did the retrofit with success used a 3q0 camera used or new from aliexpress or kufatec? I ask because i don't understand if there is a check of the VIN written in the module. I have a 3q0 camera wired and coded correctly but i can't be able to calibrate also with the help of a professionist because the calibration is stopped by the module. So i want to understand if my (aliexpress) brand new camera is not a good solution...
Do you have obd11?it was a supposition that of vin. the problem is that during the calibration phase (made by a specialist) it stops because the chamber control unit fails. with odis I checked the information a bit and the only strange thing was the unset vin and in the eeprom data indicated error or inconsistency.
gando85 said:... in the EEPROM data indicated error or inconsistency.
no problem for odbeleven only with odis i found the error in data consistency in eepromDo you have obd11?
Does it find any error when scaning ?
Friends, I'm breaking my head to calibrate the Camera, it always fails to calibrate, I've already changed its position several times. I was wondering if you guys had this difficulty to find the best position? ODIS always displays this message: CALIBRATION FAILED. CALIBRATION WAS NOT SUCCESSFUL. THE CAUSE OF THIS IS: No Relevant calibration failure. Did you have this same calibration problem?
Reaper1, you received this message at some point:No Relevant calibration failure
doesnt mean the camera isnt positioned correctly. the answer to whats the cause is in the error itself, its not related to the calibration proccess.
The camera isnt connected well, happend to me yesterday and i played with the ribbon cable until it started calibrating.
Reaper1, I'm not sure but I bought other Flat cables to test, but I'm distrusting this information: EVENT REGISTRATION: B200500- STATIC INVALID DATA BLOCK. Another thing, to do the calibration is it necessary to do the condification? I say this because whenever I start calibration I get this information on the screen, I was wondering if it happens to you too? View attachment 173581View attachment 173584View attachment 173587