Edit: accidentally uploaded the 4meg original photo. Replaced with much smaller jpeg.
Part 5 (Thursday)
Install flywheel. Place clutch on alignment tool and quadruple ocd check it's facing the right way.
Install pressure plate but first have a mini rage episode when I realize I don't have a 9mm 12point socket which I was previously certain I did. Use 9mm ratchet wrench instead while guesstimating what 15 lbft of torque feels like.
Clean all the baked on dust out of inside of tranny case and install new throw out bearing.
The above only took an hour. The next big step is lifting the case back into place. Decided I'm too tired and instead cleaned up the mess I've made so far.
Taking today off from garage to put in extra time at work. Will resume tomorrow.