GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

WTB: Revo pendulum(dogbone) mount INSTALL TOOL ONLY

Reggie Enchilada

Autocross Newbie
Location
nowhere
Car(s)
yes
The tool is pretty much useless from what I've read. My kit didn't even come with one, and I ordered the full set of mounts.

You're most likely going to destroy the OEM puck getting it out
 

Reggie Enchilada

Autocross Newbie
Location
nowhere
Car(s)
yes
Replied to your PM, but I'll update this thread for anyone that's interested.

The Revo mount should go in with little effort. I pressed it in by hand, then lightly tapped it with a deadfall hammer to make sure that it was seated correctly. A floorjack would also work well.
 

PouncingPanzer1

Go Kart Champion
I'm not worried so much about removing the oem mount as much as I am worried about installing the revo mount.

We're you able to easily slide the revo mount in properly without the tool?
Don't need it for removal or install. Deadblow hammer, or mallot, with a lil bit of silicon grease and it goes it quite easy. A little too easy if you ask me.
 
Top