7
Post your VWR springs in setups in here
- Thread starter Johnny Blaze
- Start date
Even with most springs, these cars don't have reverse rake, it's the front fenders which are a bit higher than the rear fenders, giving that appearance.
I'm guessing the reason for this is clearance/rubbing. Either way, I imagine it's designed this way for a reason.
Sent from my iPhone using Tapatalk
I'm guessing the reason for this is clearance/rubbing. Either way, I imagine it's designed this way for a reason.
Sent from my iPhone using Tapatalk
snobrdrdan
former GTI owner
- Location
- Southeast Michigan
8J0-512-149
SouthbayMK7
Ready to race!
- Location
- Pomona CA
They are thicker pads that go on top of the rear coil to help prevent the reverse rake look. I have them on mine, part # is in signature
So they go on the rear and increase the rear fender gap gotcha
How much they cost?
Sent from my iPhone using Tapatalk
snobrdrdan
former GTI owner
- Location
- Southeast Michigan
spiker369
on air, don't care
- Location
- South Florida
Is this photo pre-drop?
spiker369
on air, don't care
- Location
- South Florida
Hmm, I guess the extra weight of the DSG gearbox really does lower it more, or maybe it was just the angle of the photo. Either way, looks good!
Hmm, I guess the extra weight of the DSG gearbox really does lower it more, or maybe it was just the angle of the photo. Either way, looks good!
Maybe I should take a picture with me in it. I bet my ass weighs more than the DSG gearbox.
Finally got my VWR's installed last Friday:
Looks good, you have spacers as well, I'm I correct?
Sent from my iPhone using Tapatalk
Yep, yep. ECS flush (15/20). They were not on in the "before".