sc52
New member
- Location
- Nottinghamshire
Optical Parking System Retrofit - Solved
Scratching my head a bit on this one...
Installed OPS in a MK7 1.2 Tsi, but can't get the control unit to show up using vcds.
I've checked the power is going to the unit, and there is also power from the unit to the switch (centre console), but try as I might I can't get the unit to respond.
I connected the orange and brown can high and low wires to pins 8 and 18, although my instructions, a poor quality black and white copy of the carsystems pdf has 7 and 17 sort of written over the top - however there aren't pins in those locations in the red canbus plug.
Another thing - because the orange and brown wires weren't long enough to get over to the drivers side where the canbus is, I picked up the wires for 8 and 18 at the beige plug in the passenger footwell (tested fine with continuity tester).
So, I'm stumped at the moment and would appreciate any input.
Thanks in advance.
Simon
ps have asked the seller (ebay) the same question - but no response as of yet
Scratching my head a bit on this one...
Installed OPS in a MK7 1.2 Tsi, but can't get the control unit to show up using vcds.
I've checked the power is going to the unit, and there is also power from the unit to the switch (centre console), but try as I might I can't get the unit to respond.
I connected the orange and brown can high and low wires to pins 8 and 18, although my instructions, a poor quality black and white copy of the carsystems pdf has 7 and 17 sort of written over the top - however there aren't pins in those locations in the red canbus plug.
Another thing - because the orange and brown wires weren't long enough to get over to the drivers side where the canbus is, I picked up the wires for 8 and 18 at the beige plug in the passenger footwell (tested fine with continuity tester).
So, I'm stumped at the moment and would appreciate any input.
Thanks in advance.
Simon
ps have asked the seller (ebay) the same question - but no response as of yet
Last edited: