GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

How to replace 7.5 tail light for euro spec

Bromy9970

New member
Location
S.Korea
My Tail lights is a bulb type on Euro spec.

I purchased the DAP wiring to replace it with a 7.5 tail lights. However, the wires are different because they are not of the US type.

Below is my BCM connection number.
Left Outer :1-A71(Brake), 2-GND, 3-A60(Turn), 4-blank
Right Outer :1-C8(Brake), 2-GND, 3-C31(Turn), 4-blank
Left Inner :1-C10(Brake), 2-GND, 3-Blank, 4-C11(Reverse), 5-A72(fog)
Right Inner : 1-A65(Brake), 2-GND, 3-Blank, 4-A64 (Reverse), 5-Blank

I think some wires need to relocate up to another pin. I wonder how to connect pins Mk 7.5 and coding.
 

ZERO815

Autocross Champion
Location
Köln Germany
Car(s)
2017 GTI SE DSG
Although the NAR wiring is not meant for ROW cars you can Re-locate both outer adapter harness wires from 4 to 3 and connect the rest according to the DAP instructions. Follow the attached coding list and you should be good to go.

You could have bought a fitting harness instead too. Just PM.


Sent from my iPhone using Tapatalk
 

Bromy9970

New member
Location
S.Korea
Although the NAR wiring is not meant for ROW cars you can Re-locate both outer adapter harness wires from 4 to 3 and connect the rest according to the DAP instructions. Follow the attached coding list and you should be good to go.

You could have bought a fitting harness instead too. Just PM.


Sent from my iPhone using Tapatalk


[(3)-Leuchte20BR LA71-Fehlerort mittleres Byte DTC-DFCC 20] - 39
I could not change the coding above to OO. Because if I tried to change it, an error message occurred.(Error in input. please one hexadecimal byte, eg:ff)
The rest have been changed as you informed me.

But, The tail lamp operates normally. There is a alarm message that B133A 15[009]-Open or Short to Plus (I attached below)

Fault : https://drive.google.com/open?id=1sARY0HaTiXiTAb2TMPyn_wIrAfdt3Q_s
Channel : https://drive.google.com/open?id=1Jk-2AUJluHwJLDOvV6tYN1bFwwTX0V0A
 
Last edited:

ZERO815

Autocross Champion
Location
Köln Germany
Car(s)
2017 GTI SE DSG
"I could not change the coding above to OO."

Did you try a single 0 (Zero) instead?
 
Top