Does anyone know or could measure what the offset of the rotor is on the stoptech 328 kit. Thanks.
W Willywonka Ready to race! Location Nottingham pa Jan 15, 2018 #1 Does anyone know or could measure what the offset of the rotor is on the stoptech 328 kit. Thanks.
Nyulak Ready to race! Location SheffVill, OH Jan 15, 2018 #2 Is this measured from the flat of the hat to the surface of the rotor? If I remember, I can take one of my rotors to work and measure it.
Is this measured from the flat of the hat to the surface of the rotor? If I remember, I can take one of my rotors to work and measure it.
W Willywonka Ready to race! Location Nottingham pa Jan 15, 2018 #3 Yea. That would work. We know that the rotor is 28mm thick. So from surface of rotor to the face of the hat (wheel side, not hub) would be perfect. The more precise the better. Last edited: Jan 15, 2018
Yea. That would work. We know that the rotor is 28mm thick. So from surface of rotor to the face of the hat (wheel side, not hub) would be perfect. The more precise the better.
Nyulak Ready to race! Location SheffVill, OH Jan 16, 2018 #4 I forgot to take the rotor to work, but my step-father hooked me up with an old caliper. I measured 26 mm.
I forgot to take the rotor to work, but my step-father hooked me up with an old caliper. I measured 26 mm.
W Willywonka Ready to race! Location Nottingham pa Jan 16, 2018 #5 Thanks a lot man. I appreciate it.