TPMS instal and set up issue

Hi
It is my first post here so steady please

I've fitted 4 sensors, module and coded everything as per guide from XaGiCo.
Uploaded .zdc container successfully yesterday. But I cant set up desired pressure. No matter what I do or no matter what value I write dome in adaptation channels, it still remain the same.





At the moment that is what I have in adaptations:

;SW:5Q0-907-273-B HW:5Q0-907-273 --- Tire Pressure
;Component:RDKBERU30 H04 0009, Coding:
;EV_RDKBERU30,006001,EV_RDKBERU30_SK37.rod
;Tuesday,31,May,2016,08:57:26:58417
;VCDS Version: Release 15.7.3 Data version: 20151216
;VCID: 3462BC349FDF5E9EA5-8060

Front-axle SPECIFIED pressure comfort,26
Front-axle SPECIFIED pressure fully loaded,26
Front-axle SPECIFIED pressure standard,26
Load status selected,Fully loaded
Rear-axle SPECIFIED pressure comfort,26
Rear-axle SPECIFIED pressure fully loaded,28
Rear-axle SPECIFIED pressure standard,26
SPECIFIED pressure line selection (end of assembly line),1
Type of calibration,Menu
(1)-Write sensor identification number-Sensor identification number (sensor ID),0
(2)-Write sensor identification number-Wheel position,Left front

I can edit all of the channels apart of Load status selected - its always FULLY LOADED, if I try to change it it shows me error - OUT OF RANGE. But I can still change it from headunit however in vcds it remain the same.
I've tried to set pressure on all setting to 20, coding accepted but no changes on display or clocks.

Any suggestions? Or am I doing something wrong?

Regards

No one?