My Tail lights is a bulb type on Euro spec.
I purchased the DAP wiring to replace it with a 7.5 tail lights. However, the wires are different because they are not of the US type.
Below is my BCM connection number.
Left Outer :1-A71(Brake), 2-GND, 3-A60(Turn), 4-blank
Right Outer :1-C8(Brake), 2-GND, 3-C31(Turn), 4-blank
Left Inner :1-C10(Brake), 2-GND, 3-Blank, 4-C11(Reverse), 5-A72(fog)
Right Inner : 1-A65(Brake), 2-GND, 3-Blank, 4-A64 (Reverse), 5-Blank
I think some wires need to relocate up to another pin. I wonder how to connect pins Mk 7.5 and coding.
I purchased the DAP wiring to replace it with a 7.5 tail lights. However, the wires are different because they are not of the US type.
Below is my BCM connection number.
Left Outer :1-A71(Brake), 2-GND, 3-A60(Turn), 4-blank
Right Outer :1-C8(Brake), 2-GND, 3-C31(Turn), 4-blank
Left Inner :1-C10(Brake), 2-GND, 3-Blank, 4-C11(Reverse), 5-A72(fog)
Right Inner : 1-A65(Brake), 2-GND, 3-Blank, 4-A64 (Reverse), 5-Blank
I think some wires need to relocate up to another pin. I wonder how to connect pins Mk 7.5 and coding.