In the apps list for my 2017 (dsg, dap, dcc), it's the third one. Honest.
ICmaker
Hello ICMaker - I too am at road-block it would seem. When I launch APPS, there is no app for High Beam Memory; there are a bunch of others, but this does not appear in the list. So it would seem, I have to push the stalk every time at start-up?
That all aside, I am not sure if I've even been able to enable the coding you have posted. I ran through the first 2 sections smoothly without a hitch. But then when I went to execute the final section "Run & Acknowledge Setup", I execute Basic Headlamp Setting, but then when I go to "Acknowledge basic setting", I get an error pop up on the multi-function display for the ALS, and I note in the history log the following:
Basic settings
Control unit: 55 Headlight Regulation
Name: Acknowledge basic setting
Status:
Basic setting ended
not active
Does this indicate a problem? Otherwise, all the other settings for 'Select hardware...' and 'Remove NAR Restrictions' are still there - it was just the problem with this final step.
And just to say it again - thank you for time and generosity!